Water Damage Prevention Tips to Avoid Costly Repairs

A small water leak might create a lot of damage to your home, and it often stays unnoticed until it’s too late, at which point it’s too late, and you’ll have to pay for costly repair work. Ceilings, carpets, and walls can be expensive to restore. You’d be shocked to know that even small fixings can cost thousands of dollars.

Things to Check to Prevent Water Damage

As a homeowner, you must always know how to keep your home safe from water damage. We’ll show you how to prevent water damage in a few simple steps:

1. Check your toilets.

Look for any water that should not be there on the flooring. Take off the cistern’s top and ensure that the float is adjusted to the proper level (usually indicated by the letters WL on the inside). So it is not overflowing into the overflow pipe. Usually, all it takes is a small adjustment. Leak detection and repair can save you a lot of time and money.

2. Check your plumbing system.

Check your plumbing, especially your water pipes, both inside and outside your home. Check the area around your sinks, basins, and cabinets. Check under your sink for puddles or leaks from your pipes; also, plug your sinks and fill them up; after that, remove the plug and look for leaks underneath. If there is any water under, try to find the source of the leak; it could be a simple dripping faucet or a leaking waste that is easily fixed. If you’re looking for water damage repair, you can find them here.

3. Check your hot water cylinder.

Look for leaks, wet patches on the flooring, or even small jets of water as you inspect the valve work. Also, make sure the water isn’t pouring out of the air vent on low-pressure open vented hot water cylinders.

4. Water valves.

Most importantly, make sure that you and your family know where to turn off the water in an emergency. Knowing where your water shutoff valve is located might save you thousands of dollars in the future. There will usually be a shutoff valve in the front of your property (usually on the Council verge) with a blue lid to identify it if you have reticulated water (town supply). In addition, a water pump and the water tank shutoff valve should be turned off on the house with a non-reticulated water supply (your water comes from storage tanks).

5. Check your roofing.

Check your roof and spout outside of your home for any problems. Constantly clean out all fallen leaves from your spouting, as blocked spouting, particularly internal gutters, can cause major water damage to your ceilings. Furthermore, check roof penetrations such as chimneys and flues, especially flashings.

Loose nails or screws, broken flashings, or perhaps gaps under flashings are all indications of roof problems. Look for wet patches on your ceiling too. Roof leaks, even little ones, can quickly cause serious ceiling and structural damage. Tek screws can replace loose nails, and Plumbers Roofing Silicone can be used to reseal flashings. Learn more about property restoration here.


You must remember that it is better to be safe than sorry. If you discover any indication of a water leak anywhere, no matter how small it appears to be, have it fixed as soon as possible or fix it yourself. You might put it off and forget about it, and then the small leak turns into a large flood when you’re off shopping or on vacation.